51 Localiser les ouvertures du sillon au bas du couffin. Busque las aberturas del canal en la parte de abajo del moises. Insert tube with plastic end into channel openingA. Snap buttons should be down as shownB. A 52 Inserer le tube comportant l’extremite de plastique dans l’ouverture A du sillon. Les boutons a pression doivent etre orientes vers le bas, tel qu’illustre en B. Pase el tubo con el extremo de plastico por la abertura del canal A. Trabe los botones como se indica en B. B NOTE: DO NO

Instruction Manual Avoid injury or death - Read and understand this manual! Para instrucciones en Espanol, llamar al: 1-800-837-4044 TABLE OF CONTENTS This instruction manual is for: • Breverra Ascend DX Booster Car Seat • Breverra Ascend SE Booster Car Seat Instructions for these models are the same unless otherwise noted. . Before You Begin Important Information.....................................1 Warnings.........................................................2 Basic Information...........

NOTE: Brake levers must face rear of stroller. Rear Wheel Assembly Fold Locks Cross Tube ASSEMBLY continued 3 Secure Wheel to Axle as shown: • Push Connector onto Axle with Ribs facing in. • Slide Wheel onto Axle and push into Connector. • Slide Wheel Retainer onto end of Axle. Make sure large end of Wheel Retainer is towards Wheel. Wheel Retainer should snap into groove on end of Axle. • Snap wheel Retainer Cap over Wheel Retainer. • Line up Hub Cap tabs with slots in Wheel and snap Hub Cap in

DEDICATED TO QUALITY IMPORTANT INFORMATION Table of Contents Page: 1 Important Information 2 Warnings 3 Assembly Opening Stroller Front Wheel Assembly Locking Footrest Rear Wheel Assembly Attaching Cup Holder 5 Car Seat/Stroller Use Locking Or Unlocking Rear Wheels Attaching Car Seat Removing Car Seat 7 Stroller Use Locking Or Unlocking Rear Wheels Closing Child’s Tray Slot Canopy Positions Child’s Tray Use Seat Back Positions Securing Child With Harness 9 Folding 10 Maintenance Cleaning Cup Hol

(9 kg) and; • Height is 27 inches (69 cm) or less . Preterm or Low Birth Weight Infants A preterm or low birth weight infant may be at special risk in a vehicle or aircraft. According to the American Academy of Pediatrics, these infants may suffer breathing difficulties if improperly reclined in a car seat. Century advises that you have your physician or hospital staff evaluate your infant and recommend the proper car seat or car bed before you and your infant leave the hospital. INSTALLATION WI

• Car seat may be placed in child’s tray slot either rear-facing or forward-facing. Rear-facing Forward-facing Tongue Slot Tongue Slot Forward-facing Snap Rear-facing Snap 1 Set both rear brakes to prevent stroller from moving. 2 Be sure handle is locked in upright carrying position. DO NOT lift car seat from arm bar until you have heard a “click” sound and have checked that handle is locked. 3 Pull Red Button on front of arm bar out and lift car seat. 4 After removing car seat, insert Tongue of

Contact airline about their policy. Use this car seat only on forward-facing aircraft seats. Install car seat on an aircraft the same way it is installed in a vehicle except DO NOT use tether strap. Without Harness System: When used without harness system as a belt positioning booster seat, this restraint is not certified for use in aircraft because there is no shoulder belt available. PARTS LIST How to Order: Complete the form on the following page. Your car seat model and serial numbers MUST b

Use Height and Weight Limits..................................7 Installation with harness system and Vehicle Seat Belt............................................................8 Installation without harness system and Vehicle Lap/Shoulder Belt...................................9 Installation with harness system and LATCH....10 Placing Child in Car Seat with harness system............................................................12 Placing Child in Car Seat without harness system.............

a). Thigh straps must also be snug (fig. b). Position Head Support (on certain models) in center of car seat with ends pointing down and snap into belt slots above harness straps (fig. c). 12 PLACING CHILD IN CAR SEAT - harness system (continued) Head Support (fig. a) (fig. b) (fig. c) 13 PLACING CHILD IN CAR SEAT - without harness system A WARNING To prevent serious injury or death: * Use ONLY the vehicles Lap/Shoulder Belt system when restraining the child in this booster seat. *

DEDICATED TO QUALITY IMPORTANT INFORMATION Table of Contents Page: 1 Important Information 2 Warnings 3 Assembly and Use Playard Bassinet Changer 7 Folding and Storing Changer Bassinet Playard 9 Maintenance Cleaning 9 Replacement Parts Need Help? If you should have any problems with this product, call toll-free 1-800-837-4044 from anywhere in the U.S. or Canada or fax at 1-610-286-4555. Or write us at: Century Products P.O. Box 100 Elverson, PA 19520-9974 Attention: Customer Service Department P