For the visually impaired, each button on the Console is molded with braille characters to identify the button’s function. The Console receives signals from up to 16 Linear wireless transmitters. Activating a transmitter causes the Console’s digital communicator to send the appropriate alarm report to the central monitoring station via the standard telephone network. In addition to the central station report, audible and visual indications occur and the alarm relay energizes during an emergency
With proper installation and operation, you'll enjoy years of trouble-free use. Niles manufactures the industry's most complete line of custom installation components and accessories for audio/video systems. For a free full line catalog write: Niles, Catalog Request, P.O. Box 160818, Miami, Florida 33116-0818 TABLE OF CONTENTS INTRODUCTION FEATURES AND BENEFITS INSTALLATION CONSIDERATIONS FRONT AND REAR PANEL DETAILS 9 INSTALLATION 11 OPERATION 15 TROUBLESHOOTING GUIDE 16 SPECIFICATIONS 18 CAUTI
Remove the loudspeaker from the bag. The metal grille is installed on the loudspeaker and will need to be removed. This is easily done by rotating the mounting ‘dogs’ out with your fingers and pulling them towards the front of the loudspeaker. This will push the screw heads against the inside of the grille to work it out of the baffle. (See Figure 3) 2. At each loudspeaker location, route the wire to the input connectors, then separate the loudspeaker wire so that at least 2 inches of each condu
TO 7:00 P.M. EASTERN TIME WITH THE EXCEPTION OF HOLIDAYS. SPECIFICATIONS Model Recommended Amplifier Power Normal Impedance Frequency Response Sensitivity Frame Dimensions Hole Cut-Out Dimensions Depth Behind Ceiling CM710 7" polypropylene woofer with treated urethane surround and one fluid- cooled 13mm Kaladex tweeter. 10 to 100 watts per channel 8 ohm nominal; 6 ohm minimum 59Hz - 20kHz +/-3dB 91 dB with 2.83 V pink noise input measured at 1 meter on axis 9-1/4 inches 23.5 cm 8 inches 20.3 cm
There should be no gaps between the wall and the frame. IMPORTANT: DO NOT OVER TIGHTEN THE SCREWS! OVER TIGHTENING THEM MAY MAKE THE GRILLE DIFFICULT TO INSTALL 7. Direct the tweeter. (CM730, CM750 & CM760 only) The tweeter is directed by gently pressing on the outer edge of the tweeter housing. It will move up to 20 degrees in any direction. For critical listening, direct the tweeter towards the user’s favorite listening position. For surround sound or low volume background listening, create mo
If the wire’s movement is obstructed by anything, fill the hole(s) with spackle and try another location. 4. If the coat hanger moves freely in a complete circle and you have sufficient depth, hold the template up to the ceiling surface. The cardboard square with the circular hole is the template. The inner perforated circle within the larger circle that was removed in step 1 earlier is the paint mask. Keep it for painting the loudspeaker later. Outline the circular cutout on the ceiling surface
Installers can set custom features on the TS-1 when using a connected laptop PC and our TS-1 programming software. The TS-1 contains two connections for a Niles MultiZone System (i.e., ZR-4630, ZR-8630AV, or A4.6Ci) and IR sensor. TS-1 front Touch Screen: Hard Keys and Touch Keys appear on the back-lit Touch Screen. TS-1 back: Function Keys 102.7 FM ooo ©©© ©CD© ® L Prev Ù " Navigation Keys ^jJlOO* Next Master Keys system connector connector NILES AUDIO CORPORATION 12331 S.W. 130
Installed in a remote room location, the WS100R receives the IR commands transmitted from your existing hand-held remotes in that room. The commands are carried via a category 5 cable to your A/V equipment in another room, and instantly “repeated”. The WS100R is compatible with all current Niles infrared systems. It may be used along with, or as an alternative to, the Niles TS100, MS100, MS200, MVC100IR and CS100 sensors or the IntelliPad®. The WS100R is just one part of the three building block
Niles manufactures the industry’s most complete line of custom installation components and accessories for audio/video systems. To see the complete Niles product assortment, visit us on the Internet at: PACKAGE CONTENTS Each package contains a CM850Si loudspeaker; 1 Aluminum MicroPerf™ Grille and 1 cardboard paint mask/hole cutout template. INSTALLATION CONSIDERATIONS We recommend using the following tools and material to install your Niles CM loudspeaker: Before starting the installation, pleas
The IR commands are carried via a category 5 cable to your A/V equipment in another room, and instantly “repeated”. The TS100 represents one of the 3 building blocks necessary to complete a Niles IR repeating system: • IR Main System Unit—Models MSU140, MSU250, MSU480 and MSU440Z. • IR Sensors/Keypads—Models WS100, TS100, MS100, MVC100IR, MS200, CS100 and the IntelliPad®. • IR Flashers—Models MF1, MF1VF, MF2, MF2VF and the IRB1. An IR sensor expansion unit, Model IRH610, is available for IR repe