.................................................... 1 1.4. DESIGN METHODS AND COMPLIANCE................................................................................ 2 1.5 EQUIPMENT INSTALLATION................................................................................................ 2 1.6. GROUND HEAT EXCHANGER MATERIALS.......................................................................... 2 1.7 PIPE JOINING METHODS .................................................................

Clothes Washers Performance Requirement for Federal Purchases Washer Capacity Modified Energy Factora 1.6 to 3.5 cu. ft. 1.42 or more a) Modified Energy Factor (MEF) is the number of cubic feet of clothes washed and dried per kilowatt hour (kWh) of electricity used. MEF is calculated by dividing the tub capacity by the total energy (clothes washer, water heater and dryer) used per wash load (10 CFR 430, sub-part B, Appendix J). Buying Energy-Efficient Clothes Washers When buying residential and

Government Federal law prohibits removal of this label before consumer purchase. Clothes Washer Capacity: Standard LG Electronics Inc. Model WM268#H*** Estimated Yearly Operating Cost (when used with an electric water heater) $14 T $10 1-1-г Cost Range of Similar Models $71 130 Estimated Yearly Electricity Use $10 Estimated Yearly Operating Cost (when used with an natural gas water neater) Your cost will depend on your utility rates and use. 1 Cost range based only on standard

THIS MANUAL CONTAINS IMPORTANT INFORMATION REGARDING THE OPERATION AND WARRANTY OF THIS PRODUCT. PLEASE RETAIN FOR FUTURE REFERENCE. 4140 S.W. 30th Ave., Ft. Lauderdale, FL 33312 Toll Free: (800) 544-6986 VEC1029FPOB_ManualEN_101606 10/16/06 5:17 PM Page 1 IMPORTANT SAFETY INSTRUCTIONS WARNINGS TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, EXPLOSION OR INJURY: • This equipment employs components that tend to produce arcs or sparks. DONOT install in compartments containing batteries or flammable ma

UNITS, TANKS AND PIPING .......................10 VENT AND COMBUSTION AIR HOODS..................11 OPT ECONO/MOTORIZED DAMPER RAIN HOOD .........11 ENTHALPY SET POINT ADJUSTMENT........................11 PWR EXH/BARO RELIEF DMPR & RAIN HOOD OPT.......11 OPERATION ...................................19 COOLING SYSTEM ..................................19 PRELIMINARY OPERATION COOLING ..................19 COOLING SEQUENCE OF OPERATION .................19 NO OUTDOOR AIR OPTIONS ............

All internal unit resistances have been deducted from the total static pressure of the blower. The Factory Setting 5 Unitary Products 17 035-17233-000-C-0702 TABLE 13: STATIC RESISTANCES1 RESISTANCE, IWG CFM 15 TON 20 TON 4500 5765 7200 6000 7000 9400 WET COIL 0.1 0.1 0.1 0.1 0.1 0.1 ECONOMIZER OPTION 0.1 0.1 0.1 0.1 0.1 0.1 HORIZONTAL DUCT CONN.2 0.2 0.3 0.5 0.2 0.3 0.5 1 Deduct these resistance values from the available unit ESP values listed in the respective blower perfor

Example: For an energy consumption of 21,500 MJ per year and a natural gas tariff of 2.1 cents per MJ ($0.021/MJ), the lifetime running cost is: 21,500 x $0.021 x 12 = $5,418 The labels can also be used to estimate the lifetime greenhouse gas emissions. For each MJ of gas consumed, around 0.06 kg of carbon dioxide is emitted, so for the example above the greenhouse gas emissions are: 21,500 x 0.06 x 12 = 15,480 kg or 15.48 tonnes The actual running costs and greenhouse gas emissions will depend

2. Don’t touch electrical switches. 3. Extinguish any open flames. 4. Immediately call your gas supplier. Direct Fired Module FOR YOUR SAFETY The use and storage of gasoline or other flammable vapors and liquids in open containers in the vicinity of this appliance is hazardous. RECEIVING AND INSPECTION Upon receiving unit, check for any interior and exterior damage, and if found, report it immediately to the carrier. Also check that all accessory items are accounted for and are damage free. Turn

NOTE: The instructions in this manual are for the use of qualified individuals specially trained and experienced in the installation and maintenance of this type of equipment and related system components. Installation and service personnel are required by some states to be licensed. Persons not qualified shall not attempt to install, service, or maintain this equipment. This manual should be maintained in legible condition and kept adjacent to the heat pump pool heater or in a safe place for fu

Refrigerant Low Pressure Control: Stops the com- pressor if refrigerant suction (low side) pressure falls too low as a result of a malfunction, loss of charge or extreme cold conditions. Indicator Lamps: There are 6 indicator lamps located on the unit control panel (see Fig. 3 below): • Power (amber lamp): When lit, indicates power is applied to the unit. • Water Flow (green lamp): When lit, indicates nor- mal water flow. • Heat Demand (green lamp): When lit, indicates the actual water temperatu