Log:

Procom 21VU

Téléchargements : 0 Taille : 99 kb    Fabricant : Procom  
Catégorie : Autres outils

Procom Freestanding Electric Fireplace V50HYLC

Téléchargements : 1 Taille : 270 kb    Fabricant : Procom  
Catégorie : Cheminées

Procom Freestanding Electric Fireplace V50HYLD

Téléchargements : 0 Taille : 270 kb    Fabricant : Procom  
Catégorie : Cheminées

Procom ML300TBA

Téléchargements : 0 Taille : 281 kb    Fabricant : Procom  
Catégorie : électrique

You may blow through a drinking straw if compressed air is not available. Figure 25 - Pilot Inlet Air Hole CLEANING HEATER CABINET Air Passageways Use a vacuum cleaner or pressurized air to clean. Exterior Use a soft cloth dampened with a mild soap and water mixture. Wipe the cabinet to remove dust. 13 TROUBLESHOOTING Note : All troubleshooting items are listed in order of operation. WARNING: Only a qualified service person should service and repair heater. CAUTION: Never use a wire, needle, o

Procom ML300HBA

Téléchargements : 0 Taille : 281 kb    Fabricant : Procom  
Catégorie : électrique

Correct all leaks at once. WARNING: Never use an open flame to check for a leak. Apply a mixture of liquid soap and water to all joints. Bubbles forming show a leak. Correct all leaks at once. Pressure Testing Gas Supply Piping System Test Pressures In Excess Of 1/2 PSIG (3.5 K Pa) 1. Disconnect appliance with its appliance main gas valve (control valve) and equipment shutoff valve from gas supply piping system. Pressures in excess of 1/2 psig will damage heater regulator. 2. Cap off open end of

Procom ML200TBA

Téléchargements : 0 Taille : 281 kb    Fabricant : Procom  
Catégorie : électrique

Attaching to Wall Stud Method For attaching mounting bracket to wall studs 1. Drill holes at marked locations using 9/64" drill bit. 2. Place mounting bracket onto wall. Line up last hole on each end of bracket with holes drilled in wall. 3. Insert mounting screws through bracket and into wall studs. 4. Tighten screws until mounting bracket is firmly fastened to wall studs. Attaching to Wall Anchor Method For attaching mounting bracket to hollow walls (wall areas between studs) or solid walls (c

Procom ML200HBA

Téléchargements : 0 Taille : 281 kb    Fabricant : Procom  
Catégorie : électrique

Rooms communicating directly with the space in which the appliances are installed*, through openings not furnished with doors, are considered a part of the unconfined space. This heater shall not be installed in a confined space or unusually tight construction unless provisions are provided for adequate combustion and ventilation air. * Adjoining rooms are communicating only if there are doorless passageways or ventilation grills between them. DETERMINING FRESH-AIR FLOW FOR HEATER LOCATION Deter

Procom PL600HYLA

Téléchargements : 8 Taille : 519 kb    Fabricant : Procom  
Catégorie : Cheminées

FOR YOUR SAFETY: Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. WHAT TO DO IF YOU SMELL GAS: -Shut off supply to the appliance. -Extenguish any open flames. -Immediately call your gas supplier. Follow the gas supplier’s instructions. -If you can not reach your gas supplier, call the fire department. Installation and service must be performed by a qualified installer, service agency or the gas supplier. IMPORTANT: Read this owner

Procom PN750HYLB

Téléchargements : 0 Taille : 519 kb    Fabricant : Procom  
Catégorie : Cheminées

How heater was malfunctioning . Type of gas used (propane/LP or natural gas) . Warranty card . Usually, we will ask you to return the defective part back to retail store. PARTS NOT UNDER WARRANTY: Contact authorized dealers of this product or Parts Central if they can’t supply original replacement part (s) Call PRO-COM’s Parts Department at 1-877-8865989 for referral information. When calling PRO-COM, have ready . Model number of your heater . The replacement part number 9 ACCESSORIES Purchase t

Procom PL600HYLB

Téléchargements : 4 Taille : 519 kb    Fabricant : Procom  
Catégorie : Cheminées

Apply Teflon tape or pipe dope to the steel fittings before making any connection. BE CAREFUL! Make sure all gas connections are snug, but not over tighten! 2. Extend the gas supply system using1/2” black iron pipe from current house supply. This may be accomplished by a teeing off” or tapping into a convenient gas line connection; installing the necessary pipe for the distance required; and then installing a manual valve at exterior house wall. If pipe is to pass though a foundation or house wa





catégories