used under license * These specs are only preliminary and are not to be used for any AD copy without prior confirmation. Copyright 2000 - Curtis International

Description • Compact, efficient heater with integrated temperature and power controller for heating air or inert gases to 1300°F (700°C). A thermal sensor in the control box turns the heater power off if airflow is lost, or the inlet air temperature is too high. A built-in airflow damper controls airflow, and control potentiometer controls temperature. If operated correctly, the heater will operate continuously for 5000 hours or longer. Specifications MAXIMUM INLET PRESSURE MAXIMUM INLET AIR TE

This warranty shall not apply to any such products which shall have been repaired or altered, except by OSRAM SYLVANIA, or which shall have been subjected. OSRAM SYLVANIA shall be liable under this warranty only if (A) OSRAM SYLVANIA receives notice of the alleged defect within sixty (60) days after the date of shipment; (B) the adjustment procedure hereinafter provided is followed, and (C) such products are, to OSRAM SYLVANIA’s satisfaction, determined to be defective. THE WARRANTY SET FORTH IN

• Do not exceed rated supply voltage (120, 240V depending on model). Excess voltage may cause controller damage or failure. • NOTE: The heater may be installed in any position when used with continuous gas flow. However, with interrupted or pulsed airflow, and the heater is vertically mounted (pointing downward), the inlet air sensors may be activated and turn heater power off. This occurs due to the natural rising of heat from the barrel to the control box. This results in delayed start-up (2 m

3) Press the VOL(ume) ^ button so that "ADD/DELETE" is selected. 4) Use the CH(annel) ^ or Ў button to select the channel you wish to put into memory or to erase from memory. Note: The display will return to a normal screen in about 10 seconds. Perform "ADD/DELETE" function while this display appears on the screen. . Press the VOL(ume) ^ or Ў button to light up the channel number in LIGHT BLUE if you wish to add the channel into memory. . Press the VOL(ume) ^ or Ў button to light up the channel