- Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier’s instructions. - If you cannot reach your gas supplier, call the fire department. - Installation and service must be performed by a qualified installer, service agency or the supplier. INSTALLER: LEAVE THIS MANUAL WITH THE APPLIANCE CONSUMER: RETAIN THIS MANUAL FOR FUTURE REFERENCE If the information in these instructions are not followed exactly, a fire or explosion may result causing property damage, persona

If this is problematic or persists as the appliance is continually operated, adjust the air shutter closed as described in the previous paragraphs. Operate the appliance for a period of time as the effect diminishes, ensuring that the appliance does not develop sooty flames. When satisfied that the appliance operates properly, proceed to finish the installation. Leave the control knob in “ON” position and turn the remote switch “OFF.” Close the lower control compartment access panel. Adjustment

Buff lightly with a clean dry cloth. The glass is 3/16" ceramic glass available from your Napoleon / Wolf Steel Ltd. dealer. Do not substitute materials. Clean the glass after the first 10 hours of operation with a recommended gas fireplace glass cleaner. Thereafter clean as required. Do not clean glass when hot! If the glass is not kept clean permanent discolouration and / or blemishes may result. W415-0061 / B / 01.11.05 FIGURE 1 INSTALLATION Clean out ashes from the inside of the wood-burning

W415-0484 / A / 07.26.06 WHAT TO DO IF YOU SMELL GAS WARNINGS & SAFETY PRECAUTIONS WHAT TO DO IF YOU SMELL GAS WARNINGS & SAFETY PRECAUTIONS TABLE of CONTENTS TABLE of CONTENTS PG 2-5 INTRODUCTION Warnings and Safety Precautions Warranty General Instructions General Information Care of Glass & Plated Parts 6 - 13 VENTING Venting Lengths Air Terminal Locations Typical Vent Installations Special Vent Installations Venting Specifications 14 -18 INSTALLATION Wall and Ceiling Protection Using Flexibl

B-VENT MODEL GS28: Disconnect the on/off switch wire from terminal 3 on the valve and the second switch wire from the terminal block. Replace each connection using the wires from the wall switch/millivolt thermostat. SERIAL NUMBER NO. DE SERIE MODEL CDVS280/GDS28 APPROVED FOR BEDROOM, BATHROOM & BEDSITTING ROOM INSTALLATION. SUITABLE FOR MOBILE HOME INSTALLATION IF INSTALLED IN ACCORDANCE WITH THE CURRENT STANDARD CAN/CSA Z240MH SERIES GAS EQUIPPED MOBILE HOMES, IN CANADA OR IN THE UNITED STATES

The kits contain seven louvers plus one louver with two pre-drilled holes (eight total) and these instructions. INSTALLATION INSTRUCTIONS Step 1. Turn off the fireplace and allow it to cool before proceeding. Step 2. Slightly lift and pull the existing top louver assembly away from the fireplace. Step 3. Slightly lift up the bottom hinged panel to disengage the small hooks on ether side of the panel. Pull forward and lower the panel down to open. Remove the assembly from the fireplace by rem

Replace the black louvers with the brass or brushed stainless louvers (without the pre-drilled holes) using the existing brackets. Step 5. Repeat Step 4 for the bottom louver assembly. Make sure to replace the pre-drilled black louver with the pre-drilled brass or brushed stainless louver. Existing Bracket Center Bracket (For No.’s H1526 thru H1529 Only) Existing Bracket Existing Bracket Figure 1 Center Bracket (For No.’s H1526 thru H1529 Only) Existing Bracket Louver (With Pre-Drill

1-1/4" x 4"-1/2 x 9" #2. 1-1/4" x 3" x 9" #3. 1-1/4" x 4-1/2" x 4-1/2" #4. 1-1/4" x 4-1/2" x 9" #5. 1-1/4" x 2-1/2" x 4-1/2" #6. 1-1/4" x 1-1/2" x 4-1/2" #7. 1-1/4" x 4-1/2" x 9" * (light weight) #8. 1-1/4" x 2-1/4" x 9" #9. 1-1/4" x 2-1/4" x 6-1/8" #10. Fibre baffle - 9” x 1” x 12” #11. Fibre baffle - 9” x 1” x 16 1/2” #12. Fibre baffle - 9” x 1” x 9 3/4” #13. Fibre baffle - 9” x 1” x 9 3/4” BACK SIDES TOP FLOOR FRONT FINISHING 10 10 MODEL 1100/1100C/1100L/1150 - FIGURE 21 11 11 MODEL 1400 / 14

NAPOLEON reserves the right to have its representative inspect any product or part thereof prior to honouring any warranty claim. ALL SPECIFICATIONS AND DESIGNS ARE SUBJECT TO CHANGE WITHOUT PRIOR NOTICE DUE TO ON-GOING PRODUCT IMPROVEMENTS. NAPOLEON® IS A REGISTERED TRADEMARK OF WOLF STEEL LTD. PATENTS U.S. 5.303.693.801 - CAN. 2.073.411, 2.082.915 & DES 417,497(12.07.1999). © WOLF STEEL LTD. W415-0223 / D / 01.12.04 GENERAL INSTRUCTIONS GENERAL INFORMATION GENERAL INSTRUCTIONS GENERAL INFORMAT

REPLACEMENT PANELS ARE AVAILABLE THROUGH YOUR LOCAL LENNOX DEALER AND MUST BE INSTALLED BY A LICENSED OR QUALIFIED SERVICE TECHNICIAN. These are direct-vent appliances. They are designed to operate only with the glass enclosure panels properly installed. Generally the glass enclosure panels should not be removed except to gain access to the components within the firebox, and the appliance may only be operated without the front glass enclosure panel in place for very brief periods of time during