Seal each vent section by injecting a liberal amount of HITEMP RTV silicone sealant into the gap. Use Diameter “PL” Vent If venting outside of shaded area. 4” 0’ 0’ 5’ 5’ 10’ 10’ 15’ 20’ 25’ 30’ 33’ Vent must have a support bracket every 5’ when on the exterior wall. If appliance is installed above 4,000’ elevation, always use 4” diameter venting. Vent height and run exceed the distance shown in the un-shaded region of chart. must not To achieve optimum performance, keep vent runs as short as po

Stove owners without a “SUPER” or “E Z Clean” grate must remove clinkers manually, some times several times a day. Stove owners using a “SUPER” or “E Z Clean” grate and quality pellets may experience days or even weeks of burning without the need to remove any clinkers from the grate. NOTE: To reduce clinkering, pull and push the “E Z Clean” grate handle a few times, at least twice a day. Be sure to leave it pushed in all the way before leaving the stove (see “Cleaning your EZ Clean” grate”). FI

My local “Pelpro” dealer is: Manufactured by: Contact local building or fire officials about restrictions and installation inspection requirements in your area. Toll Free Technical Support 1 - 866 -456 -9269 To register your purchase FPP Bay View Freestanding IPP Bay View Insert / Built-In FPP Freestanding IPP Insert / Built-In READ THIS ENTIRE MANUAL BEFORE YOU INSTALL AND USE YOUR HEATER. FAILURE TO FOLLOW INSTRUCTIONS MAY RESULT IN PROPERTY DAMAGE, BODILY INJURY OR EVEN DEATH! Installation sh

4. Adjust the FUEL RATE and the FAN SPEED to your desired settings you require upon completion of startup sequence. 1. Push firmly on the FEED RATE or START touch pad. -The COMBUSTION FAN (exhaust) will start and operate at full speed for 60 seconds, then adjust downward to match feed rate #1 -The CONVECTION FAN (heating) will start and the LED will go solid on LOW setting -The AUGER CYCLE LED will go solid for 3 seconds, indicating signal being sent to auger motor. -The IGNITER LED will light u