9 Cycles, Options and Lights...................................... 10-14 What Can & Cannot Be Washed.................................. 14 Care & Cleaning................................................................. 15 Troubleshooting ........................................................... 16-18 Warranty and Service ....................................................... 19 Guide d’utilisation et d’entretien.................................. 20 Guia de Uso y Cuidado ......................

This will make cleaning easier when soiled from cooking. The special cooktop cleaning cream leaves a protective finish on the glass to help prevent scratches and abrasions. Before Setting Surface Controls induction Cookware Minimum Pan Size Requirements INCORRECT CORRECT NOTE: Pan bottoms should not extend more than V2" (13ram) beyond outer Cooking Zone (induction). • Cookware not centered "Cookware centered correctly on Cooking Zone surface. on Cooking Zone surface. W Fig. 2 .... !iiiii! ii ! l

• Do not use a small pan on a large element. Not only does this waste energy, but it can also result in spillovers burning onto the cooking area which requires extra cleaning. • Do not use non-flat specialty items that are oversized or uneven such as round-bottom woks, rippled bottom and/or oversized canners and griddles. • Do not use foil or foil-type containers. Foil may melt onto the glass. If metal melts on the cooktop, do not use. Call an authorized servicer. Cookware Recommendations Using

Installation Instructions Instructions d’installation/Instrucciones de Instalacion Sealed Gas Cooktop/Table de cuisson avec bruleurs a gaz scelles/ Cubierta sellada a gas CORRECT BON CORRECTO YELLOW JAUNE AMARILLA BLUE LIFTING FLAMME BLEUE SE SOULEVANT AZUL QUE SE SEPARA DEL QUEMADOR A23 NATURAL/NATUREL/ GAS NATURAL A24 Replace grommets./Remettez les anneaux./Vuelva a colocar las arandelas. Replace knobs. /Remettez les boutons. /Vuelva a instalar las perillas. A25 LO OFF LO OFF LO OFF LO OFF A26

Press (_ for 6 seconds (Fig. 1). G 2. To increase the temperature use the number pads to enter the desired change. (Example 30°F) (_) (Fig. 2). The temperature may be increased as much as 35°F (19°C). 3. Press (_ to accept the temperature change and the display will return to the time of day (Fig. 3). Press _ to reject the @ change if necessary. To adjust the oven temperature lower: 1. Press (_ for 6 seconds (Fig. 4). G 2. To decrease the temperature use the number pads to enter the desired chan

Do not let clothing or other flammable materials contact hot surfaces. • Do Not Use Water or Flour on Grease Fires--Smother the fire with a pan lid, or use baking soda, a dry chemical or foam-type extinguisher. • When heating fat or grease, watch it closely. Fat or grease may catch fire if allowed to become too hot. • Use Only Dry Potholders--Moist or damp potholders on hot surfaces may result in burns from steam, Do not let potholders touch hot heating burners. Do not use a towel or other bulky

-Tape Measure -Electric Drill -Torx (T-20) Head Screwdriver -1/8” Drill Bit -5/32” Drill Bit -Masking Tape -Safety Glasses -Original Installation Instructions Additional items required if using handle provided with dishwasher: -.” – 20 bolt, 2 .” long -.” Drill Bit ALL ELECTRICAL WIRING, GROUNDING AND PLUMBING SHOULD BE DONE IN ACCORDANCE WITH NATIONAL AND LOCAL CODES BY QUALIFIED INDIVIDUALS CHECK LOCAL PLUMBING CODES FOR APPROVED PLUMBING PROCEDURES AND ACCESSORIES. This appliance must be conn

Destroy the carton and plastic bags after unpacking the range. Never allow children to play with packaging material. • Proper Installation--Be sure your appliance is properly installed and grounded by a qualified technician in accordance with the National Electrical Code ANSI/NFPA No. 70 latest edition and local electrical code requirements. install only per installation instructions provided in the literature package for this range. Ask your dealer to recommend a qualified technician and an aut

Only flat-bottom cookware should be used. The type and size of cookware, the number of surface elements in use and their settings, are all factors that will affect the amount of heat that will spread to Figure 1 areas beyond the surface elements. The areas surrounding the elements may become hot enough to cause burns. About the Radiant Surface Elements The element temperature rises gradually and evenly. As the temperature rises, the element will glow red. To maintain the selected setting, the el

26 Oven Cleaning .................................................................... 27-30 Preparing for the Self-Clean Cycle ................................... 27 Self-Clean Cycle ............................................................... 28 Delayed Self-Clean Cycle ............................................ 29-30 Adjusting Oven Temperature ................................................. 30 General Cleaning ................................................................ 3%34 Oven Li