This plug wi fit in a polarized outlet only one way. If the plug does not fit fufy In the outlet reverse the plug. If it still does not fit contact a qualified electrician to install the proper outleL Do not change the plug in any way. SAVE THESE INSTRUCTIONS FOR HOUSEHOLD USE ONLY Commercial use of this unit voids the manufacturer's warranty. 1 SETUP Powerful Steam Jets O Crease Making Tool ► Attach to the syeamer head to use with shirt cuffs and cottars and/or creating creases in pants

Turn the grooved tubes on each side of the support to fasten, then hang the steam head between the prongs at the top. • Align the shoulders of the garment on the hanger and allow it to hang freely. • When pressing clothing, temperature, humidity and pressure are important. Because the steam released is of high temperature (212SF). temperature and humidity conditions for easy pressing are sufficient. Since clothing is hung from the support and hangs freety. the pressure on the garment may be w

basic safety precautions should always be observed, including the following: 1. Read all instructions before using your 17. floor sanitizer. 2. Use the system only for its intended use. 3. Do not use outdoors. 4. Do not leave your floor sanitizer unattended when plugged in. Turn it off and unplug the electrical cord from the outlet when not in use. 5. Do not allow to be used as a toy. Pay close attention when used near children, pets or plants. Do not leave your floor sanitizer unattended w

Make sure to use only water. 13. To refill the product with water during use: ® Unplug the power cord. @ Press the steam button to fully discharge all air held inside. © Wait three minutes for the steam held within to settle and dispel. @ Press the steam button once again to fully discharge all steam remaining inside. © Turn and open the safety cap. 14. The product becomes hot during use. Exercise care when substituting accessories. 15. To provide continued protection against risk of ele

the following basic safety precautions should always be followed when using an electrical appliance. READ ALL INSTRUCTIONS BEFORE USING YOUR STEAM CLEANER 1. DO NOT leave your Steam Cleaner unattended when plugged in or not in use. 2. This unit is not a toy. Close supervision is required when using unit near children, pets, and plants. Steam produced by unit is hot and pressurized. Care must be taken to avoid burns or other injuries. Never point nozzle at people or pets. 3. Always unplug ele

HAAN Corporation assumes no responsibility for any errors that may appear in this document nor does it make expressed or implied warranty of any kind with regard to this material, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose. HAAN Corporation shall not be liable for incidental or consequential damages in connection with or arising out of the furnishing, performance, or use of this document and the program materials which it describ

Fig 3 • 50% untreated tap water with 50% distilled or demineralized bottled water 4) Once removed from the main body, turn the Water Reservoir up to show the grey stopper. (Fig 3) 5) Grasp the tab on the stopper and gently pull the stopper out (Fig 4). Remove it only enough to allow for adding water. DO NOT break the connecting elastic band. Fig 4 6) Add water to the reservoir thru the stopper hole until the reservoir is full. Do not overfill. Carefully replace the stopper and close it securely

Q: Do I have to use distilled water? A: No. But if the tap water in your area is hard it is recommended that distilled/purified water be used to extend the life of your handheld cleaner. Q: Does the HAAN work on pet stains? A: Yes, the HAAN is able to spot clean fresh pet stains by loosening and lifting the stain. Q: Why can’t I open the Pressure Locking Safety Cap during operation? A: The high water temperature and pressure inside the tank present a safety hazard. The cap is designed so that it

HAAN Corporation shall not be liable for incidental or consequential damages in connection with or arising out of the furnishing, performance, or use of this document and the program materials which it describes. Edition 1, January 2009 Printed in Korea Product manufactured in China All rights reserved. No part of this document may be photocopied, reproduced or translated to another language without prior written consent of HAAN Corporation. HAAN engineering clean™ is a trademark of HAAN Corpora

Hold the steam head vents away from you and steam in a vertical up and down motion. This will allow the condensation in the hose to flow back into the steamer. Fig 13 Fig 14 16) Press the Power Button to turn the unit on. Hold the steam head up and facing away from you for the 40 seconds it takes to heat up. once you see that a steady steam vapor is emitted from the steam head, the Steam Station is ready to use. 17) Hold the wand of the steam head firmly and slowly move it across the surface to