Log:

Turbo Air TCB-4SD

Téléchargements : 1 Taille : 203 kb    Fabricant : Turbo Air  
Catégorie : Dispensers

This system contains R404A or R134A refrigerant and polyolester lubricant. The polyol ester lubricant has rapid moisture absorbing qualities. 2. Drier replacement is very important and must be changed when a system is opened for servicing. A 620 copper drier or better is highly recommended. 3. Micron level vacuums must be achieved to insure low moisture levels in the system. 500 microns or lower must be obtained. 4. When compressor is grounded, suction filter drier and 620 drier or better must b

Turbo Air TCB-4SB

Téléchargements : 1 Taille : 203 kb    Fabricant : Turbo Air  
Catégorie : Dispensers

Any parts, covered under this warranty, that are determined by Turbo Air to have been defective within one (1) year of original installation or fifteen (15) months after shipment date from manufacturer, whichever occurs first, is limited to the repair or replacement, including labor charges, of defective parts or assemblies. The labor warranty shall include standard straight time labor charges only and reasonable travel time, as determined by Turbo Air. Additional Four Year Compressor Warranty I

Turbo Air TCB-3SD

Téléchargements : 0 Taille : 203 kb    Fabricant : Turbo Air  
Catégorie : Dispensers

Compressor determined by Turbo Air to have been defective within this extended period will, at Turbo Air’s option, be either repaired or replaced with a compressor or compressor parts of similar design and capacity. The four (4) year extended compressor warranty applies only to hermetically sealed parts of the compressor and does not apply to any other parts or components, including, but not limited to, cabinet, paint finish, temperature control, refrigerant, metering device, driers, motor start

Turbo Air TCB-3SB

Téléchargements : 2 Taille : 203 kb    Fabricant : Turbo Air  
Catégorie : Dispensers

If compressor is replaced under warranty, Turbo Air will either request the compressor or compressor tag be returned. Compressor or tag must be returned with all information related to the unit. Any action or breach of these warranty provisions must be commenced within one year after said cause of action has occurred. One Year Parts & Labor Warranty Turbo Air warrants to the original purchaser of every new Turbo Air refrigerated unit, the cabinet and all parts thereof, to be free from defects in

Turbo Air TCB-2SD

Téléchargements : 1 Taille : 203 kb    Fabricant : Turbo Air  
Catégorie : Dispensers

This system contains R404A or R134A refrigerant and polyolester lubricant. The polyol ester lubricant has rapid moisture absorbing qualities. 2. Drier replacement is very important and must be changed when a system is opened for servicing. A 620 copper drier or better is highly recommended. 3. Micron level vacuums must be achieved to insure low moisture levels in the system. 500 microns or lower must be obtained. 4. When compressor is grounded, suction filter drier and 620 drier or better must b

Turbo Air TCB-2SB

Téléchargements : 0 Taille : 203 kb    Fabricant : Turbo Air  
Catégorie : Dispensers

3 Beer Line & CO2 Line Installation Schematic Diagram..................................... 4 Caution "IMPORTANT" .................................................................................... 5 INSTALLATION................................................................................................ 7 CLEANING ....................................................................................................... 8 BASIC OPERATION ..........................................................

Turbo Air TBD-4SD

Téléchargements : 1 Taille : 203 kb    Fabricant : Turbo Air  
Catégorie : Dispensers

-Do not use an abrasive cleaner because it will scratch the surface. 2. CLEANING THE CONDENSER FINS -To maintain proper refrigeration performance, the Condenser coil must be free of dust, dirt, and grease. This will require periodic cleaning. Condenser fins should be cleaned at least every three months (90 days) or as needed. -To clean condenser, unplug the unit. Condenser can be cleaned with vacuum, brush, or CO2 (high pressure air). 3. CLEAN THE GASKET -The door gasket should be cleaned freque

Turbo Air TBD-4SB

Téléchargements : 1 Taille : 203 kb    Fabricant : Turbo Air  
Catégorie : Dispensers

2 SERIAL NUMBER ............................................................................................ 2 INSTALLATION OF THE CASTERS.................................................................3 Draft Arms Towers Installation Schematic Diagram......................................... 3 Beer Line & CO2 Line Installation Schematic Diagram..................................... 4 Caution "IMPORTANT" .................................................................................... 5 INSTA

Turbo Air TBD-3SD

Téléchargements : 6 Taille : 203 kb    Fabricant : Turbo Air  
Catégorie : Dispensers

1. POWER CORD -Be sure the power cord is connected to the proper voltage, and amps should be run before connecting power cord to outlet. -A protected circuit of the correct voltage and amperage must be run for connection of the line cord. -Unplug the unit, whenever performing maintenance functions or cleaning the refrigerated cabinet. -Compressor warranty is void if burnt out due to low voltage. 2. RE-STARTING -If unpluged, wait 5 minutes before re-starting. 6 Turbo air INSTALLATION 1. GOOD AIR

Turbo Air TBD-3SB

Téléchargements : 0 Taille : 203 kb    Fabricant : Turbo Air  
Catégorie : Dispensers

This system contains R404A or R134A refrigerant and polyolester lubricant. The polyol ester lubricant has rapid moisture absorbing qualities. 2. Drier replacement is very important and must be changed when a system is opened for servicing. A 620 copper drier or better is highly recommended. 3. Micron level vacuums must be achieved to insure low moisture levels in the system. 500 microns or lower must be obtained. 4. When compressor is grounded, suction filter drier and 620 drier or better must b





catégories