Log:

ARC Audio 2050 XXK

Téléchargements : 11 Taille : 4 mb    Fabricant : ARC Audio  
Catégorie : Avtousiliteli

Manufactured to the highest standards of quality and reliability to deliver years of listening enjoyment. ARC Audio...SOLID CONSTRUCTION for SOUND Car Audio Systems. Features • Built-in variable 12 db per octave Crossover • Crossover Range 55Hz-5.5kHz • Stereo / Bridged / Mono Input mode selector switch • Bass Boost 0-18 dB @ 45 Hz • Short circuit, thermal, reverse voltage, over-voltage and DC offset protection. • Very high damping factors. • Optically Isolated Mosfet Power Supply. 1

ARC Audio 430-8-01

Téléchargements : 4 Taille : 1 mb    Fabricant : ARC Audio  
Catégorie : Avtousiliteli

By using a higher voltage for the preamp drives we overcome the internal loss of the transistors, making the channel operate like the The balanced inputs will accept speaker level input from most head units. Internal balanced line conversion will deliver balanced output after the RCA’s are connected. Balanced line carries 4 channels of signal. Remote level control selectable for front or rear. Stereo gain controls allow prefect level matching. Input mode switch for total control of the signal

ARC Audio ARC 10D2

Téléchargements : 8 Taille : 174 kb    Fabricant : ARC Audio  
Catégorie : Haut-parleurs

The size and vent tuning frequency, if you're using a ported box, determine the low-frequency extension and output of the subwoofer. We have designed the ARC Audio subwoofer to perform well when used in both sealed and ported enclosures. The acoustics of your vehicle also influence bass response. The small interior size of most cars and trucks boosts low frequencies dramatically. You will need to use a smaller enclosure then normal to achieve a flat bass response. As a rule, below 50Hz (dependin

ARC Audio ARC 10D4

Téléchargements : 20 Taille : 174 kb    Fabricant : ARC Audio  
Catégorie : Haut-parleurs

We have designed the ARC Audio subwoofer to perform well when used in both sealed and ported enclosures. The acoustics of your vehicle also influence bass response. The small interior size of most cars and trucks boosts low frequencies dramatically. You will need to use a smaller enclosure then normal to achieve a flat bass response. As a rule, below 50Hz (depending on cabin size), bass response increases at about 12dB per octave as the frequency decreases. This "Cabin Gain" adds significant bas

ARC Audio ARC 12D2

Téléchargements : 2 Taille : 174 kb    Fabricant : ARC Audio  
Catégorie : Haut-parleurs

What does this mean? Your amp does not make power, it takes power from your battery and converts it into a different form. The subwoofer is just another kind of converter. It changes AC voltage from the amp into changes in air pressure (that's sound is) and HEAT. The more energy being converted the more heat. A speaker can not reproduce DC voltage (produced when an amp clips) but this energy must go somewhere. It is all converted into heat. This is why clipping is so dangerous to a speaker. A gr

ARC Audio ARC 12D4

Téléchargements : 3 Taille : 174 kb    Fabricant : ARC Audio  
Catégorie : Haut-parleurs

Sound deaden, it will sound better and hit harder. Building an Enclosure It is recommended that you use 3/4" MDF (Medium Density Fiberboard) to build an enclosure. Glue all your joints with yellow glue and secure then with screws or nails. Make sure the enclosure will fit and that you have adequate room to get it in and out of the vehicle. Calculating Enclosure Volume It is difficult to give exact box dimensions that are universal for all cars and trucks. It is for this reason that you must be a

ARC Audio ARC 15D2

Téléchargements : 3 Taille : 174 kb    Fabricant : ARC Audio  
Catégorie : Haut-parleurs

To do this, you must divide the cubic inch total by 1728 . Example 1512 cu in 1728 = .875 Cubic feet. Calculating Internal Volume 1) To calculate the internal (net) volume of the above box you must first multiply the thickness of the wood you are using by Two (2). Example: ." x 2 = 1 1/2" 2) Next subtract 1.5" from each of the outside measurements of the box. Width 12" -1.5" = 10.5" . Height 14" -1.5" = 12.5" . Depth 9" -1.5" = 7.5" 3) Multiply the new totals (H x W x D) Example: 10.5" x 12.5" x

ARC Audio ARC 15D4

Téléchargements : 6 Taille : 174 kb    Fabricant : ARC Audio  
Catégorie : Haut-parleurs

ARC Audio ARC 8D2

Téléchargements : 8 Taille : 174 kb    Fabricant : ARC Audio  
Catégorie : Haut-parleurs

The ported box design will offer more output then the sealed enclosure (about 3 - 4 dB more), but it will reduce the power handling and require more space to install. The recommended ported enclosure is not designed for “competition SPL” performance, it is designed for normal listening. It will increase the low frequencies output and increase the overall volume while still sounding good when properly tuned and installed. A Note About Power Handling ARC Audio woofers are designed to perform for y

ARC Audio ARC 8D4

Téléchargements : 6 Taille : 174 kb    Fabricant : ARC Audio  
Catégorie : Haut-parleurs

This is the MAX power rating. Continued use of this woofer at greater then the RMS power rating will result a damaged (burnt) voice coil. This damage is considered abuse and is NOT covered under the warranty. Small Amp Myth Under powering a woofer is fine. This woofer will suffer no damage from a 100 watt amp if it is correctly tuned. However, even a small amp that is being over driven (clipped) can destroy a sub. Use your power wisely. Clipping can be heard as a dull thud or a popping sound. If





catégories