Then loop the bend under the cord retaining clips as shown. This will prevent the extension cord from detaching from the hedge trimmer plug. Misuse of this Hedge Trimmer will void the warranty. ie: cutting hedges or shrubs over 1/2" in diameter or foreign objects such as wires, rocks, or fences. Before trimming check work area for foreign objects such as wires, cords, glass, fences, or rocks. Be sure to remove any foreign objects from the work area. Failure to properly maintain this hedge trimme

1 8 61032502730 Key, Woodruff 1 9 10000006962 Piston, Kit Includes items 10-14 1 10 10001105330 Ring, Piston 2 11 10001504630 Circlip, Piston Pin 2 12 10001408960 Spacer, Piston Pin 2 13 10011305930 Bearing, Needle 1 14 10001311520 Pin, Piston 1 15 10101044332 Gasket, Cylinder Base Included in kit 88900045131 1 16 10101106561 Cylinder 1 17 90016205022 Bolt 5 x 22 2 18 90023804018 Screw 4 x 18 2 19 10150612821 Cover, Cylinder 1 H. SV-4B (H2) Type IE Engine Parts Assembly- Double Edge SV-4B (H2) T

(64 cm) de longitud Modelo 2300 Manche 60" (152 cm) Lames 20" (51 cm) Modele 2310 Barra de 60 pulg. (152 cm) Cuchillas de 20 pulg. (51 cm) de longitud Modelo 2310 EXTENDED REACH HEDGE TRIMMERHEDGE TRIMMER T TTAILLE-HAIES AILLE-HAIESAILLE-HAIES A LONG MANCHE PODADORA DE SETOS PODADORA DE SETOSPODADORA DE SETOS DE LARGO ALCANCE © 2003 Little Wonder, Div. of Schiller Pfeiffer Inc. All Rights Reserved. Table of Contents Important Information A. Introduction . . . . . . . . . . . . . . . . . . . . .

Use an approved tester. Sparks can ignite fumes. Don’t crank engine with spark plug removed. If the engine is flooded, open the choke and pull recoil until engine starts. If this fails, read and follow the section “Operation” (Pg. 8). Don’t run engine when the odor of gasoline is present or other explosive conditions exist. Don’t operate the unit if gasoline is spilled. Clean up spill completely before starting engine. Don’t refuel indoors or in an improperly ventilated area. Don’t operate your

All Rights Reserved. Owners Manual and Safety Instructions Table of Contents A. Introduction . . . . . . . . . . . . . . . . . . . . . . . .1 B. Log Splitter Specification . . . . . . . . . . . . .1 C. Unpacking and Assembly Instructions . .2 D. Service Information . . . . . . . . . . . . . . . . .5 E. Special Safety Information . . . . . . . . . . . .5 1. Safety Decals . . . . . . . . . . . . . . . . . . . . . . . .5 2. Safety Warnings . . . . . . . . . . . . . . . . . . . . . .7 3. Important e

All Rights Reserved. ASPIRADORA DE ALTO RENDIMIENTO ASPIRATEUR HAUTE PERFORMANCE © 2004 Little Wonder, Division de Schiller Pfeiffer Inc. Tous droits reserves. © 2004 Little Wonder, Division de Schiller - Pfeiffer, Inc. Todos los Derechos Reservados. Models 5601 and 5611 Modeles 5601 et 5611 Modelos 5601 y 5611 © 2004 Little Wonder, Div. of Schiller-Pfeiffer Inc. All Rights Reserved. ASPIRADORA DE ALTO RENDIMIENTO ASPIRATEUR HAUTE PERFORMANCE © 2004 Little Wonder, Division de Schiller Pfeiffer I

To remove nozzle assembly (for purposes of storage, or clearing blockages): • Turn engine off and disconnect spark plug • Loosen hose clamp on the front plate with flathead screwdriver or 5/16 wrench • Slide hose off of front plate inlet • Bend one side of nozzle bracket inward and twist the assembly to remove the hook from the axle • Twist back and lift to remove the other side of nozzle bracket from the axle WARNING DANGER NEVER RUN OR OPERATE YOUR MACHINE UNLESS DISCHARGE BAG IS ATTACHED, AND

IMPORTANT SAFETY INSTRUCTIONS WARNING ! ! To avoid injury when using your Honda Edger, follow basic precautions, including the following: 1. READ THESE IMPORTANT SAFETY INSTRUCTIONS, THE OPERATING INSTRUCTIONS, ASSEMBLY INSTRUCTIONS, USER MAINTENANCE INSTRUCTIONS, AND THE HONDA OPERATING AND MAINTENANCE INSTRUCTIONS CAREFULLY AND COMPLETELY. Be thoroughly familiar with the controls and the proper use of the equipment. Know how to stop the unit and disengage the controls quickly. SAVE MANUALS AND

**Synthetic oils will provide better starting in extreme cold (below -10.F). 10 a. Gasoline/Alcohol blends: Gasohol (up to 10% ethyl alcohol, 90% unleaded gasoline by volume) is approved as a fuel for Kohler engines. Other gasoline/alcohol blends are not approved. b. Gasoline/Ether blends: Methyl Tertiary Butyl Ether (MTBE) and unleaded gasoline blends (up to a maximum of 15% MTBE by volume) are approved as a fuel for Kohler engines. Other gasoline/ether blends are not approved. 2. Fuel Warnings

All Rights Reserved. LITTLE WONDER® Shredding Models 8221 and 8271 © 2005 Little Wonder, Div. of Schiller-Pfeiffer Inc. All Rights Reserved. LITTLE WONDER® Shredding Models 8221 and 8271 Table of Contents Important Information Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 Service Information . . . . . . . . . . . . . . . . . . . . . . . . . .1 Special Safety Information . . . . . . . . . . . . . . . . . . . .1 Safety and Warnings Safety Decals . . . . . . . . . .