Log:

Strong Pools and Spas Barcelona

Téléchargements : 0 Taille : 312 kb    Fabricant : Strong Pools and Spas  
Catégorie : Autres accessoires pour la maison

Long exposure at higher temperature can result in dizziness and/or hyperthermia. Hyperthermia occurs when the internal temperature of the body reaches a level several degrees above the normal body temperature of 98°F (36.7°C). The symptoms of hyperthermia include dizziness, fainting, drowsiness or lethargy. The affects of hyperthermia include: • Unawareness of impending hazard • Failure to perceive heat • Failure to recognize the need to exit the spa • Physical inability to exit the spa • Fetal

Strong Pools and Spas Freedom

Téléchargements : 1 Taille : 321 kb    Fabricant : Strong Pools and Spas  
Catégorie : Autres accessoires pour la maison

A location should be selected to compliment your lifestyle, the view from your house and the ability to supervise the spa. Position the spa in relation to the surroundings of trees, sunlight exposure, wind, bathroom location, landscaping and evening lighting. The spa with water is very heavy, if the spa is placed on flooring or decking, be sure the structure is strong enough to support the weight. The necessary support should be at least 75 pounds per square foot. Install your spa, in a way that

Strong Pools and Spas Grand Cayman Spa

Téléchargements : 0 Taille : 357 kb    Fabricant : Strong Pools and Spas  
Catégorie : Autres accessoires pour la maison

If the opposite direction is desired, release the button and let the display revert to the current water temperature. Press the button to display the set temperature, and again to make the temperature change in the desired direction. after 3 seconds, the LCD will stop flashing and display the current temperature. Light There are several color options in our spas and by pressing the light button in quick succession the customer can cycle through the different lighting options. BEFORE START UP! IM

Strong Pools and Spas Liberty

Téléchargements : 0 Taille : 331 kb    Fabricant : Strong Pools and Spas  
Catégorie : Autres accessoires pour la maison

OWNER’S MANUAL Liberty ™ 3204 Point Township Drive (Rte 11) • P.O. Box 108 Northumberland, PA 17857 1-800-STRONG-9 1-800-787-6649 12/20/06 Table of Contents Introduction ................................................................................................................................. 1 Health Safety.............................................................................................................................. 2 Installation -Spa placement ............................

Strong Pools and Spas Madrid

Téléchargements : 0 Taille : 310 kb    Fabricant : Strong Pools and Spas  
Catégorie : Autres accessoires pour la maison

WINTERIZING Before draining, power must be turned off at the GFCI circuit breaker. Attach a garden hose to the faucet and open it. Water will start to drain. You can use the water to water the garden. You can also siphon the water from the spa. The drain faucet will not remove all the water. You may have to remove a small amount of water by hand, using a towel. You must also use a wet-vac to remove the water from the lines by suction and/or blowing. Water left in the line and jets might freeze a

Strong Pools and Spas Maui Spa

Téléchargements : 3 Taille : 304 kb    Fabricant : Strong Pools and Spas  
Catégorie : Autres accessoires pour la maison

Freeze Protection If the temperature sensors detect a drop to below 44.F/6.7.C within the heater, the pump will automatically activate to provide freeze protection. The equipment stays on until 4 minutes after the sensors detect that the spa temperature has risen to 45.F/7.2.C or higher. 9 Spa Maintenance The maintenance and care of your spa is simple and easy to carry out, and if performed regularly as scheduled, problems will be minimal. It is important that the following procedures be read th

Strong Pools and Spas Monaco

Téléchargements : 0 Taille : 285 kb    Fabricant : Strong Pools and Spas  
Catégorie : Autres accessoires pour la maison

This type of chemical can be added in quantities of 0.5 ounce per 500 gallons of spa water. Check the chlorine level at least seven hours or more after adding to determine the full effect of the added chemical. Liquid chlorine is not recommended. ORGANIC POLYMERS - are used in various forms. These chemicals clear up cloudy or dirty water appearance and prevent calcium deposits on the inside spa finish, plumbing and heating equipment. Use as recommended by the manufacturer. METAL GON - or its equ

Strong Pools and Spas Patriot Spa

Téléchargements : 0 Taille : 298 kb    Fabricant : Strong Pools and Spas  
Catégorie : Autres accessoires pour la maison

OWNER’S MANUAL Patriot ™ 3204 Point Township Drive (Rte 11) • P.O. Box 108 Northumberland, PA 17857 1-800-STRONG-9 1-800-787-6649 12/20/06 Table of Contents Introduction ................................................................................................................................. 1 Health Safety.............................................................................................................................. 2 Installation -Spa placement ............................

Strong Pools and Spas RIO Rotational Molded resin whirlpool spa

Téléchargements : 1 Taille : 353 kb    Fabricant : Strong Pools and Spas  
Catégorie : Autres accessoires pour la maison

This spa must be on adedicated circuit. CAUTION: OWNER’S MANUAL ™ More than one GFCIused on the electricalcircuit will render thisspa inoperable. This spa must be on adedicated circuit. P.O. Box 108 Northumberland, PA 17857 1-800-STRONG-9 1-800-787-6649 1/9/07 Table of Contents Introduction ................................................................................................................................. 1 Safety Instructions.........................................................

Strong Pools and Spas Rio Spa

Téléchargements : 0 Taille : 741 kb    Fabricant : Strong Pools and Spas  
Catégorie : Autres accessoires pour la maison

This secondary circuit will automatically shut off in 30 min if left on. No display at topside* • Check that connection to main board is clean and sound at J8. • Test a new topside control • Check for 120V primary power going into the transformer and for 12V secondary power out of the transformer to J6 and J7 on the board before replacing the transformer. • Relace board if there is 12V to J6 and J7. Display flashes “th1/38” on system start up* • Check that temperature sensing probe connection to





catégories