G 1-22-04 Rev. G 1-22-04 P/N 471048 27 INSTALLER: AFFIX THESE INSTRUCTIONS TO OR ADJACENT TO POOL & SPA HEATER Pentair Pool Products, Inc. 1620 Hawkins Ave., Sanford, NC 27330 • (919) 774-4151 10951 W. Los Angeles Ave., Moorpark, CA 93021 • (805) 523-2400 A-1 PowerMax™ Pool & Spa Heater OPERATION & INSTALLATION MANUAL (APPENDIX) PowerMax™ Pool and Spa Heater INTRODUCTION This manual provides information for the proper installation, operation and maintenance of the PowerMax pool and spa heater. P

C 7-6-01 1 P/N 075122 3. The "SM/SMBW" Series Filter has been listed and approved by the National Sanitation foundation. This booklet will enable you to install and operate your pool filter in the correct manner. Correct installation and operation will result in the trouble free operation of a quality product, as well as prevent unnecessary repairs. 4. Model SMBW Filter System a. Standard SM Series Filter with built-in backwash valve. Simplifies plumbing installations. 5. Model SM Filter System

clearance for one of the door panels. The heater is design certified by CSA International for installation on combustible flooring. For installation on carpeting, the heater must be mounted on a metal or wood panel that extends at least three inches (10cm) beyond the base of the heater. If the heater is installed in a closet or alcove, the entire floor shall be covered by the panel. On an outdoor shelter installation, the exhaust discharges into a vent pipe. Orient the heater so that the vent pi

Do NOT sanitize the pool by putting chlorine tablets or sticks into the skimmer(s). When the pump is off, this will cause a high concentration of chlorine to enter the heater, which could cause corrosion damage to the heat exchanger. WATER PRESSURE SWITCH WARNING Hazardous pressure. Do not bypass the Water Pressure Switch or render it inoperable. Switch Settings The water pressure switch turns off the burner if the water flow is interrupted. If the water flow is restricted, the water pressure sw

4. Toggle-Style Valve: Pull toggle toward you to turn gas off. 5. Replace the Access Door Panels. OPERATING CONTROL The five operating switches are: POOL ON Press this button to govern heater operation by the pool temperature setting. SPA ON Press this button to govern heater operation by the spa temperature setting. HEATER OFF Press this button to switch off the heater. ^ ^^ TEMP Press this button to raise the temperature setting. Ў ЎЎ TEMP Press this button to lower the temperature setting. To

WARNING Pipe relief valve discharge to a drain or other safe disposal site. 2681 1096 Relief Valve Installed User supplied pipe fittings Turn star wheel to raise pressure set point if pressure switch is more than 2 feet (0.6M) below water level FIGURE 19: Relief Valve FIGURE 18: Water Pressure Switch Adjustment Turn star wheel to lower pressure set point if pressure switch is more than 5 feet (1.5M) above water level Raise Pressure Lower Pressure A reference scale is on the back of pressure swit

All rights reserved This document is subject to change without notice 1620 Hawkins Ave., Sanford, NC 27330 • (919) 566-8000 10951 West Los Angeles Ave., Moorpark, CA 93021 • (805) 553-5000 Trademarks and disclaimers PowerMax, MegaTherm and the Pentair Commercial Pool and Spa logo are trademarks of Pentair Water Pool and Spa, Inc. Other trademarks and trade names may be used in this document to refer to either the entities claiming the marks and names or their products. Pentair Water Pool and

SECTION II. INSTALLATION 1. Check carton for any evidence of damage due to rough handling in shipment. If carton or any pump components are damaged, notify freight carrier immediately. 2. After inspection, carefully remove pump from carton. 3. The pump should be secured to a flat solid foundation, high enough to prevent flooding of the motor. A sheltered location is best, being sure to allow for adequate ventilation. P/N 350039 Rev. C 8-24-06 3 4. Provide space and lighting for routine maintenan

MegaTherm is designed to deliver efficiencies as high as 82%. Integral finned copper tubes are rolled directly into the headers, and conformal heat exchanger baffles and an eight-fins-per-inch tubing configuration maximize combustion heat extraction. We’ve also designed MegaTherm to be simple to service. Heat exchanger header covers are field-removable for complete inspection of tubing and header passages, and the heat exchanger is replaceable without disassembly of the burners or combustion cha

Cable can trip or entangle swimmers which could result in drowning. Do not leave your cleaner in the pool when not in use. Doing so, will reduce the life of your Filter Bag and cleaner. After removing your cleaner from the pool you should clean and re-install the Filter Bag. Then, rest your cleaner on all four wheels in a dry, shaded area along with its Power Supply and properly coiled Floating Cable. Off-Season Storage When the Pool Season is over, you should thoroughly clean the Filter Bag. Ma